Gude GSH-3S-VL-TC-2 Traducción Del Manual Original página 33

not store the ADF filter in a moist environment.
Check the filter before each use. As soon as the
function and appearance no longer appear to be in
the intended condition, you can no longer use the
product.
Caution! Never use a product that is
damaged! A damaged product does not
provide enough protection and may
therefore lead to injuries and/or accidents.
Before each use, inspect the safety goggles with
regard to damage and service life.
If the filter flickers or the level of darkening no longer
corresponds to the default value or if other abnormal
working conditions predominate, the welding hel-
met may no longer be used.
Ensure that this product is not exposed unnecessari-
ly to sunshine.
Use only original accessories and original spare parts.
Components for which there are no instructions for
exchanging should be replaced by the manufacturer
only.
Caution! Using eye protection without a
filter effect against optical radiation damages
the eyes.
Before each use, check whether the eye protec-
tion shows the necessary number on the scale.
The welding helmet with automatic darkening is not
suitable for laser and gas welding.
Never place the welding helmet on hot surfaces.
Do not open the welding helmet under any
circumstances.Repairs and works specified in these
Instructions may only be performed by qualified
authorised staff.
Ensure that you have set automatic darkening before
each welding process.
If the filter does not darken automatically, stop
the welding process immediately and contact the
manufacturer.
Replace the protective visor if it is scratched or
damaged.
The welding helmet does not protect against
impacts.
Caution! Materials that come into contact
with the wearer's skin may cause allergic
reactions in individuals with sensitivities.
Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under the
influence of drugs, alcohol or medication.
The appliance must not be used if damaged or safety
equipment is defective. Replace any worn-out and
damaged parts.
The device must not be operated if it is damaged in
any way.
Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's ope-
ration. If damaged, have the power tool repaired
before use.
Eye protection devices worn to protect
against high-speed particles may constitute a
hazard for the wearer as a result of the transfer
of impact forces if worn over standard
prescription glasses.
Caution! Risk of high-speed particles at
extreme temperatures.
Should protection against high-speed particles at
extreme temperatures be required, the eye pro-
tection device selected must feature the letter T
right after the letter for the impact intensity, i.e.
FT, BT or AT. If the letter for the impact intensity
is not followed by the letter T, the eye protection
device may be used only to protect against high-
speed particles at room temperature.
Before each commissioning, check whether the
welding helmet and the protective panel are intact.
If the protective panel has any scratches, cracks or
unevenness, it must be replaced before use, or it may
cause serious injuries.
SYMBOLS
Read the operating instructions to redu-
ce the risk of injury.
The appliance must be stored in a dry place
and protected from frost.
Keep the machine out of reach of children.
ENGLISH
29