Functions - Berner 419689 Operación Manual

Functions

(Page 2)
1. ON/OFF
2. Origin resetting
3. Battery-cover
4. remo–veable thumbroll
5. Fixing screw
Specifications:
Measuring range: 0 – 150 mm/6"
max. operational speed: ± 1,5 m/sec.
Repeatability: ± 0,01 mm
Storage temperature: 5 °C – 40 °C
Battery replacement:
Open the battery cover on top by pulling right side. Replace battery, anode
pointing upwards. Then close the battery cover carefully.
Notes:
Please prepare with measuring very carefully. Keep surfaces clean.
The caliper should be regularly cleaned with cotton-cloth. Do not use
petrol. Do not expose the caliper direct to the sun light, ultraviolet rays or
extreme temperatures. Prevent it from any shock and do not immerse the
caliper in any liquid.
Electric etching or engraving by high voltage can destroy the
electronic chip, no warranty will be given!
Never dismantle the caliper housing. The battery should be taken out, if
no use for a long time. Do not give used batteries in refuse. Please give it
to a special collecting depot.
Electr. digital caliper
Operation manual
:
6. Metric / Inch conversion
7. Display
8. Depth Gauge
9. Measuring jaws for outside
measurement
10. Measuring cross-tips for inside
measurement
Accuracy: ± 0,03 mm
Power supply: battery (1.5 V, type LR44)
Resolution: 0,01 mm, 0.0005"
Humidity influence: 0 – 80 %
EN
6