Safety Warnings For Water Pumps - PRETUL HIDR-1/2x24P Manual

Safety Warnings
for Water Pumps
Adequate Uses
• The equipment is a stationary device designed to pump
neutral, clean liquids with no abrasive solids suspended,
with temperature not above 104 °F (104 °F for pumps with
plastic drivers or diffusers). Any other type of use is
inadequate.
• The device is in compliance with the security most
updated requirements only if it is used the way it is
designed. The device can only be used under the
performance restrictions admitted.
• It shall not be used to pump explosives, fuels or
aggressive materials or substances hazardous to health or
sewage water.
• The device is not adequate for commercial or industrial
use.
• The inadequate use or modifications to the device, the
use of the components that are not approved or tested by
the manufacturer may result in unforeseen damage to the
device and the operator and relieves the manufacturer of
legal liability.
CAUTION • Do not install the device outdoors or
wet areas.
WARNING • Do not install the device in areas
where there is danger of explosion or near combustible
liquids or gases.
• Do not aim the water jet against the
WARNING
device or other electrical components. There is danger of
death due to electric shock.
• Double check the power cable is not
CAUTION
making contact with the water running close to the device.
• Any repairs shall only be carried out in a
Authorized Service Center. Otherwise,
there is danger of being exposed to an electric shock and
voids the Warranty.
• The symbols adhered to the device shall not be removed
nor be covered. All the information about the device that is
not legible shall be replaced immediately.
• Read and obey the operations instructions before
installing and starting the equipment. Any damage caused
by omitting these instructive indications may damage the
equipment and voids the Warranty.
• The pump shall be connected through a residual current
switch designed with a short circuit current not higher than
30 mA.
ENGLISH
5