Tabla de contenido
Manuales relacionados para PRETUL HIDR-1/2x24P
Resumen de contenidos para PRETUL HIDR-1/2x24P
- Página 1 Manual Hydro Tank Capacity 6.3 gal 13.2 gal Pneumatic 20183 20184 Pressure Applies for: Codes Models Boosting System 20183 HIDR-1/2x24P 20184 HIDR-1/2x50P Read the user’s manual thoroughly CAUTION before operating this tool.
-
Página 2: Tabla De Contenido
Installation Keep this manual for future references. Pressure Switch The illustrations in this manual are for reference Start Up only. They might be different from the real tool. Maintenance Troubleshooting Notes Authorized Service Centers Warranty Policy HIDR-1/2x24P HIDR-1/2x50P ENGLISH... -
Página 3: Technical Specifications
Technical Specifications HIDR-1/2x24P HIDR-1/2x50P Code 20183 20184 Description Hydro Pneumatic Pressure Boosting System Voltage 127 V Frequency 60 Hz Current 3.5 A Speed 3450 RPM Inlet and Outlet Diameter 1” x 1” Maximum Suction Depth 26.2 ft Maximum Height (Maximum value of 65.6 ft... -
Página 4: General Power Tools Safety Warnings
General Power Tools Safety Warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For Water Pumps
Safety Warnings for Water Pumps CAUTION • Do not install the device outdoors or Adequate Uses wet areas. WARNING • Do not install the device in areas • The equipment is a stationary device designed to pump where there is danger of explosion or near combustible neutral, clean liquids with no abrasive solids suspended, liquids or gases. -
Página 6: Parts
Parts Pump-tank inter-connection hose Water Closed electric motor Outlet Manometer with external ventilation Peripheral pump Power Cable Pressure Switch (pressurestat) Water Input Support to fix the Tank equipment Purging ENGLISH... -
Página 7: Installation
Installation Set Up • The equipment shall be installed in a dry place, safeguarding from outdoors and allowing air flow for its correct ventilation (A). Environment temperature shall not exceed 104 °F. • Use bolts to fix the equipment to a concrete base to prevent any vibration (B). The hydro pneumatic equipment shall be installed in horizontal position to assure good performance. -
Página 8: Electric Connection
Installation Electric connection • Ask a professional electrician to make the power connection to the power supply. Comply with the corresponding mandatory rules. • The fixed installation shall incorporate a device to assure the omni-polar disconnection of the energy feed. •... -
Página 9: Maintenance
Maintenance • The hydro-pneumatic equipment does not require maintenance only if the following caution measures are followed: • When there is risk of freezing, empty the pump completely removing the suction pipe (B). Remember to purge the pump before starting it again. •... -
Página 10: Notes
Notes ENGLISH... -
Página 11: Authorized Service Centers
Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 0187-8737 to get information about the nearest Service Center. -
Página 12: Warranty Policy
Code Model Brand 20183 HIDR-1/2X24P 20184 HIDR-1/2X50P This product is guaranteed for 1 year. To make the warranty valid or purchase parts and components you must present the product in Corregidora 22, Col. Centro, Alc. Cuauhtémoc, CDMX C.P. 06060 or at the...