KUNERT IVENTO Manual De Instrucciones página 10

wheels, first position them parallel to the rest of the pram and then turn the rim to the right
(fig. 29). In order to unlock the front wheels to go in all directions, simply turn the rim to the
left.
FOLDING AND UNFOLDING THE PRAM CHASSIS
To unfold the pram chassis, lay it down flat, push the lock (fig. 1) and pull it up strongly while
holding the handle until the locking mechanism will lock into place (fig. 2).
WARNING! Before using the pram, ensure the locking mechanisms are activated, if not, pull
them tighter.
The chassis may be folded in two ways (with and without wheels):
- to fold the chassis with the wheels, first lock the front wheels by positioning them across the
to the pram. Then, press the lock button with your thumb (fig. 3) and then simultaneously pull
the levers on both sides of the handle (fig. 4).
- to fold the chassis without wheels, take off two front wheels (fig. 5) and rear wheels (fig. 6).
Then, press the lock button with your thumb (fig. 3) and simultaneously pull the levers on both
sides of the handle (fig. 4).
PARKING DEVICE
To activate the parking device, you need to step on the lever at the bottom of the pram (fig. 28).
The parking device will be released when the lever is lifted.
FOOTREST ADJUSTMENT
The footrest can be adjusted by simultaneously pressing side buttons while putting it in the
desired position (fig. 19).
MOUNTING AND REMOVAL OF REAR WHEELS
Before mounting the wheels, first mount the axes in the pram chassis. In order to mount the
axes, push the larger end of the axis into the absorber by pressing the red button, and then
release the button. Mount the axes on both sides of the pram and check whether fixed
properly (fig. 9).
To mount the rear wheels, press the metal button in the central part of the wheel (fig. 6) and
then slide the wheel on the axis as far as it will go, release the button and pull back the wheel
until you hear a "click" sound.
Always check whether the wheels are mounted correctly. In case the pram wheel comes of
when pulled, repeat the wheel mounting procedure until mounted properly.
FASTENING THE HARNESS
In order to fasten the harness, click the ends of the harness in hooks on both sides of the
carrycot. (The harness is not provided with the pram). To unbuckle the harness, press on the
sides of the buckle and pull them apart.
ADJUSTMENT OF THE BACKREST IN THE CARRYCOT
To raise or lower the backrest of the carrycot, pull and turn the handle as shown in the photo
(fig. 30)
GUIDELINES AND WARNINGS
- Before assembling the pram, ensure that all the components are fit to use. If they are damaged,
the product should not be used.
- When you fold and unfold the pram, ensure that the child is at a safe distance.
- The parking device must be used every time the pram is stopped.
- While adjusting the pram, you must ensure that no moving parts are directly touching the child.
- Any additional weight on the handle of the pram, the front/back of the seat and/or sides of the
pram makes it unstable.
- When going up a curb or any other step, it is important that you lift the front wheels.
- Store the pram in an area inaccessible to the child.
The pram must not be ridden down the stairs.
The pram should only be used with its original parts authorized by the manufacturer.
The chassis of the pram is compatible only with an original carrycot, seat and car seat provided by
the manufacturer. Only original components included in the set guarantee full compatibility and
proper functioning of the pram.
Every Kunert pram is marked with the company logo for product identification purposes.
10