Level The Dryer; Final Check - Avanti SED67D0W Manual De Instrucciones

LEVEL THE DRYER

To ensure that the dryer provides the optimal drying performance, it must
be leveled. To minimize vibration, noise, and unwanted movement, the
floor must be a perfectly level, solid surface.
•
Adjust the leveling feet only as much as necessary to level the dryer.
Extending the leveling feet more than necessary can cause the dryer to
vibrate.
POWER ON
Make sure all gas connections (Gas Models only), exhaust and electrical
connections are complete. Plug in your dryer.

FINAL CHECK

•
Make sure the dryer is plugged into an electrical outlet and is properly
grounded.
•
The exhaust ductwork is hooked up and the joints are taped.
•
A plastic flexible duct in NOT used.
•
Use rigid or stiff-walled flexible metal vent material.
•
The dryer is leveled and is sitting firmly on the floor.
•
Gas models - the gas is turned on with no gas leakage.
•
Start your dryer to confirm that it runs, heats, and shuts off.
CAUTION
The burner may not ignite initially due to air in the gas line. Allowing
your dryer to operate on a heat setting will purge the line. If the gas
does not ignite within 5 minutes, turn your dryer off and wait 5 minutes.
Be sure the gas supply to your dryer has been turned on. In order to
confirm the gas ignition, check the exhaust for heat.
27
level
Loosen lock
Adjustable legs