Zamel exta free RZB-01 Manual De Instrucciones página 9

OPERATION, MOUNTING ROP-01
All manuals and user guides at all-guides.com
Disconnect power supply by the phase fuse, the circuit-breaker or the switch-discon-
nector combined to the proper circuit.
Check if there is no voltage on connection cables by means of a special measure
equipment.
Connect the cables with the terminals in accordance with the installing diagram.
Install ROP-01 device in installation cable box.
Switch on the power supply from the mains.
The device can operate in five modes:
MONOSTABLE the relay operates only while pressing transmitter's push-button.
BISTABLE (one push-button) the device changes relay status cyclically always after
pressing the same push-button.
SWITCH ON the device switches on after pressing the push-button.
SWITCH OFF the device switches off after pressing the push-button.
TIME the device switches off according to the adjusted time (tp), but it may be switched
off before adjusted time finishes. Default settings - 15 seconds.
CAUTION! Adjusted time will not be deleted.
RADIO TRANSMITTERS PROGRAMMING
MONOSTABLE mode:
Press transmitter's push-button for a longer time.
Press PROG push-button of ROP-01 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button.
Release transmitter's push-button. LED red diode switches on (first signal pulsates,
next the signal is constant).
Press the same transmitter's push-button and release it. LED red diode switches on
(the signal pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
BISTABLE mode:
Press PROG push-button of ROP-01 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button.
Press the transmitter's push-button for a longer time. LED red diode switches on (first
signal pulsates, next the signal is constant).
Release transmitter's push-button. LED red diode switches on (the signal pulsates),
next the LED red diode switches off - it means the TRANSMITTER IS ADDED.
SWITCH ON/SWITCH OFF mode (two push-buttons):
Press PROG push-button of ROP-01 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button.
Press and release transmitter's pushbutton. LED red diode switches on (first signal
pulsates, next the signal is constant).
Press and release the same transmitter's push-button. LED red diode switches on (the
signal pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
TIME mode (one push-button)
Press PROG push-button of ROP-01 device for a longer time till LED red diode switch-
es on (constant signal). Next release PROG push-button.
Press and release transmitter's pushbutton. LED red diode switches on (the signal
pulsates, next the signal is constant).
Press and release the same transmitter's push-button. LED red diode switches on (the
signal pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
An exemplary programming procedure. The procedure for the rest of radio EXTA FREE
transmitters is analogous.