Tolerance Mode - Keysight Technologies U1701B Guía Del Usuario Y Servicios

2 Features and Functions

Tolerance Mode

The tolerance mode has 1%, 5%, 10%, and 20% tolerance ranges. To enter the
tolerance mode, insert a standard value into the socket. Press the TOL key to set
the display value as the standard reference. Similarly, the DH value which appears
on the primary display can be used as a standard value to sort the components.
Press TOL key again to cycle through 1%, 5%, 10% and 20% tolerance and select
the desired tolerance. The meter range locks as tolerance mode.
This mode can not be set under following condition:
–
–
–
This function is designed for sorting the values. The beeper will beep three times
when the reading is out of the selected tolerance. A single beep represents that
the reading is within the selected tolerance.
To exit tolerance mode, press and hold TOL key for more than 1 s
NOTE
30
After setting the recording mode.
After setting HI/LO Audible Alert mode.
The tested display is either OL or below 10 count.
Keysight U1701B User's and Service Guide