Panasonic EW-DJ4B Manual De Instrucciones página 13

If the water tank cap
comes off
• Align the groove of the
water tank cap with the
protrusion of the water
supply port, and press the
water tank cap into place
until it clicks.
3
Press the level switch to
select your desired water
pressure level.
• After you press the level
switch, the last used water
pressure level is automatically
selected. Then each time
you press the level switch,
the water pressure level is
switched once in the following
order: 1 (weak) → 2 → 3 → 4
(strong) → 1...
EW-DJ4B EU0713.indb 13
Protrusion
Groove
• When the appliance has not been used for a long
4
Clean inside your mouth with
the water jet.
a Place the nozzle in your
b Close your mouth gently.
c Turn on the power switch " ".
• You can switch the water
LEV EL
Press
• If the main unit is tilted too
Strong
(water pressure level 4)
Weak
(water pressure level 1)
About the water pressure level memory
function
The last selected water pressure level will be
remembered, from which the appliance will
start next time.
time or when the battery is used up, the water
pressure level will return to 1.
mouth.
pressure level by pressing the
level switch, even while using
the appliance.
much, the water does not
come out from the nozzle.
A fully filled water tank provides approximately
40 seconds of use.
(When the water pressure level is set to 4)
Point 1
Keep your face
over the basin.
Point 2
Place the main
unit upright.
※ It can also be used in a bath.
13
2022/7/14 下午1:40