Problem
The appliance
does not operate.
The water jet is
poor.
No water comes
out.
The nozzle is hard
to install.
Water leaks from
the bottom cover.
If the problems still cannot be solved, contact the store where you purchased the unit or a service centre authorized
by Panasonic for repair.
EW-DJ4B EU0713.indb 19
Possible cause
The battery has reached
▶
the end of its life (approx.3
years).
The appliance is used with
▶
approximately 5 °C or lower.
The nozzle is clogged. The
▶
outlet of nozzle is squashed.
▶
The filter is clogged.
The main unit is tilted too
▶
much.
It may take some time to suck
▶
up water.
▶
▶
▶
▶
▶
The rubber ring of the bottom
▶
cover is not installed properly.
Have the battery replaced by your dealer or an
▶
authorized service centre.
Use the appliance in an ambient temperature
▶
approximately 5 °C or higher.
▶
Replace the nozzle with a new one.
Remove the dirt from the filter.
▶
(See page 17.)
Please use the appliance
▶
with the main unit upright.
(See page 13.)
Put water into the nozzle
port a , install the nozzle,
▶
and turn on the power
switch.
Apply water to the nozzle
▶
insertion port b .
Please install it properly.
▶
(See page 16.)
Action
b
a
19
2022/7/14 下午1:40