Baby Trend Lil' Snooze Deluxe III PY86H Serie Manual De Instrucciones página 6

ASSEMBLY
TO ASSEMBLE PLAYARD
Playard
ATTENTION: Playard must be fully assembled and securely locked before installing or using
other accessories.
1) • Unzip bag and remove playard frame (Fig. 1).
Unfasten straps and set the mattress aside.
DO NOT push center down yet.
2) • Top rails must be fully locked before lowering
center. Pull up one rail at a time, hold one hand
on each side of the rail and pull up sharply, do
not pull from the middle where the center latch
release is located, make sure both tubes latch in
place and each rail is rigid (Fig. 2).
IMPORTANT: The center must be raised while
locking the rails. If one rail will lock but the
other side will not then, unlock the rail by
squeezing the release in the center and try
again.
3) • Once all four (4) top rails are locked in place,
push down on the center handle (Fig. 3a). The
center mechanism automatically locks in place.
7
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
IMPORTANT: Test each top rail by pushing
down slightly to confirm each is rigid and
securely in place before use (Fig. 3b).
Mattress 4) • Place the Playard mattress with the padded
5) • Underneath the mattress Insert the hook &
Fig. 1
Fig. 2
Fig. 3a
side facing up (Fig. 4).
loop through the sloted floor of the playard
(Fig. 5a). Fasten the hook and loop to the
underside of the playard floor (Fig. 5b).
IMPORTANT: The handle located in the
center of the Playard floor MUST remain
raised (Approx. 45.7 cm or 18 inches) while
locking the side rails in place. If the center is
not raised the rails will NOT lock.
If you experience difficulty and one side of
the rail will lock but the other side will not
then, unlock the rail by squeezing the release
in the center and try again. If you still have
difficulty, contact our Customer Service
Center at 1-800-328-7363 or visit us online at
www.babytrend.com.
Fig. 5a
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
ASSEMBLY
Fig. 3b
Fig. 4
Fig. 5b
8