VDO SAA110287EA Manual De Instrucciones página 60

Setting the Skew Angle in Ocean Line antennas
If you have determined the correct skew angle, follow the steps below to adjust the
antenna's LNB skew angle.
1. Turn off the antenna and disconnect power to all wired components
2. Using the screwdriver, remove the screws securing the radome. Then
remove and set it aside in a safe place
3. Localize the LNB assembly on the back of the antenna reflector
Figure A-2
4. Loosen the four screws fastening the LNB
5. Adjust the LNB clockwise or counter-clockwise, until the skew arrow on the
LNB points to the skew angle that you determined earlier
(+) direction
Figure A-3
6. Tighten the four screws
Caution – To avoid bodily injury, be sure to turn off the antenna and
disconnect the power to all wired components.
The back of the Ocean Line antenna reflector
Ocean Line LNB Skew Angle adjustment
Caution – Be sure to keep the LNB fully inserted into the hall to ensure
the optimum performance
Satellite Antennas User Manual ver. 2.0
Reflector
LNB
(-) direction
LNB
59