Directions For Use; Control Operation - Guardian Technologies H997 Instrucciones De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper
air flow. Place the humidifier on a water-resistant surface, as water can damage furniture and
some flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING -
Make sure unit is unplugged.
1. Remove the tank lid.
WATER REFILL INDICATOR
When the unit is low on water the display will show an error E1 until the unit is refilled or turned
off. Add more water to continue use. Unit will automatically resume running when the tank has
been refilled.

CONTROL OPERATION

Power Button - Press to turn the power on/off
Sleep Mode - Press to turn the sleep mode on/off. The display will show "SP" for
5 seconds then the product will enter into Sleep Mode. All lights besides sleep mode
turn off and the unit runs in low speed.
Timer - Set the scheduled shutdown time from 1 to 12 hours shown on the display,
the product will shut down after the timer expires
Humidity Setting - Press to select the preferred humidity level. The humidity range can
be set from 40% to 75%RH. Recommended humidity is between 45-50%. When the
ambient humidity reaches the select setting, the unit will turn off until the ambient humidity
drops back to >5%RH lower than the select setting, then the unit will work automatically.
CO = no humidity level set
HI = ambient humidity is more > 80%RH
LO = ambient humidity is < 30%RH .
Mist Output - Press to select speed: 1-3
Night light - Press once to turn on the 7 color night light. Continue to press up to 8 times
to circulate through and select a color. The 9th press turns the light off.
Display - Displays the ambient humidity, timer, setting humidity, speed, water shortage
indicator(E1).

DIRECTIONS FOR USE

2. Pour cool, clean water directly into
the tank using a water pitcher.
Fill to-max-line on Mist Tube.
3. Return the tank lid.
E-5

Publicidad

Tabla de contenido
loading

Tabla de contenido