Charging Mode - Beta 1839BRW Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
1) Magnet slot
2) LED charge indicators
3) Charging slot

CHARGING MODE

Connecting wireless charging base to power socket
Connect the USB-C cable of the transformer to the power socket of the wireless charging station, 1839BRW.
For proper operation of the wireless charging base, the supplied USB-C cable and power supplies should be used;
alternatively, cables/power supplies with equivalent characteristics can be used ("Technical Data" table).
Using any cables or power supplies other than the recommended ones can result in incorrect operation of the wireless charging
base.
When the wireless charging base is supplied with power, the LED lights are solid green, to indicate that the lamps or the smartpho-
ne can be charged.
Lamp charge
- The lamps must be charged when off.
- Place the back of the lamp to charge on one of the two slots of the wireless charging base, 1839BRW, making the magnet
fit the slot.
- If the lamp that needs charging is not placed correctly or there is something between the lamp and the wireless charging base,
the LED turns red.
- If the LED is blinking green on the wireless charging base, charging is underway.
- Check the charging level on the lamp.
- When charge is completed, the lamp can be disconnected from the wireless battery charger.
Smartphone charge
- Pull the button on the bottom left, to open the charging compartment, and fit in the smartphone horizontally (see figure).
- If the smartphone that needs charging is not placed correctly or there is something between the smartphone and the wireless
charging base, the LED turns red.
- If the LED is blinking green on the wireless charging base, charging is underway.
- Check the charging level on the smartphone.
- When charge is completed, the smartphone can be disconnected from the wireless battery charger.
6
EN I