Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Model
BOXEL E-BATT
* The battery life is indicative, it may vary depending on the type of concrete, temperature and work cycle.
MODEL
BOXEL
E-BATT
2.2 BATTERY DESCRIPTION
The battery is assembled inside the aluminiun housing to resist external agents and impacts. The
battery charge connector is accessible from the outside and it is protected against dust and water
both in its closed position and once the charger connector is connected.
¡ATENTION!: The battery is not detachable.
en
2.3 CHARGER DESCRIPTION
The BOXEL E-BATT charger has a connector for the battery and a cable that connects the charger
to the mains.
It includes a LED indicator to check the status of the charge; red in charge and green when the
battery is fully charged.
The charger can be used from 110V to 240V. Use the appropriate plug for the available socket of the
mains.
Fully insert the charger connector into the BOXEL E-BATT and screw the connector by hand.
The battery charge rate is 5 Ah. If the battery is fully discharged, it needs 2.5 hours for a full charge,.
In 2 hours it gets about 96% of charge.
Use only indoors, do not expose the charger to humidity.
ATTENTION! Use only the charger 104517.
BATTERY POWERED ELECTRONIC CONVERTER
BOXEL E-BATT
4
Dimensions [cm]
length
width
heigth
54
29
20
ELECTRIC FEATURES
BATTERY
Ah
V
15,9
68,4
Battery life using pokers ENAR*
weight
Kg
M38AF
M5AF
13
120 min
95 min
Wh
cell type
1087
Li-ion
M6AF
M7AF
65 min
40 min
OUTPUT
VOLTAGE
FREQUENCY
42V 3Ph
200Hz
M8AF
55 min
Publicidad
Tabla de contenido
