Key To Symbols - Beta 1498BC/12 Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
RECHARGING PORTABLE STARTER
• Connect the charge cable to the type C USB port (4) on the starter.
• Insert the adapter in the socket.
• When charging, the indicators will flash intermittently.
• All the indicators will switch off when the charge is paused or is complete.
Charge indicator
The energy levels during the charging stage are displayed on the 'indicator'.
Indicator
Charge percent
3
USING THE STARTER
1. Connect the blue connector (9) to the starter socket (3), making sure that the cable's LEDs are off.
2. Connect the red clamp to the battery's positive (+) terminal. Connect the black clamp to the battery's negative (-) terminal or
to a ground point.
3. Follow the instructions below:
• Steady green light: The connection is correct and the circuit works, the vehicle's engine can be switched on. Switch on the
engine within 30 seconds.
• Flashing green light: The vehicle's battery is completely flat, press the 'BOOST' button (9), wait until the 'GREEN LIGHT'
is steady and switch on the engine within 30 seconds.
• Red light with buzzing sound: The connection is incorrect, correct the connection of the clamps as indicated in 'POINT 2',
wait until the 'GREEN LIGHT' is steady and switch on the engine within 30 seconds.
• Red light without buzzing sound: After checking that the connection of the clamps is correct, this indicates that the
vehicle's battery may be damaged. Carefully check the condition of the battery and the electrical system before attempting
to start the vehicle.
4. After starting the vehicle, remove the starter from the battery, disconnecting the red clamp (+) first. Leave the engine running.
USING THE STARTER AS A BATTERY CHARGER FOR ELECTRONIC DEVICES
The starter is able to charge smartphones or tablets.
• Connect the cable to the output port for rapid charging.
• Select the correct connector and connect it to the electronic device.
• Touch the button on the starter (1), it recognises the parameters of the electronic devices and starts to charge them.
• Never charge two devices at the same time as this could cause damage.
8
Off Steady 1
0% 25%
2
1
4
6
5
Steady 2
50%
8
7
Steady 3 Steady 4
75% 100%

KEY TO SYMBOLS

1) Switch
2) Indicator
3) Socket for the clamp cable
4) Input/output port – Type C
5) USB output port
6) Rapid USB output port
7) LED light
8) Output port
9) Clamp cable + "BOOST"
EN I