Publicidad
Starting a Warm Motor
• Set the blower on its base on leveled ground.
• Set the switch in the ON position (A).
• Press and release the primer bulb 10 times (B).
• Press the throttle trigger and block with the blocking
button (C).
• Move the choke lever to "
• Pull the jack-line until the motor starts running (E).
• When it starts, let it run 10 seconds in this position (F).
• Set the choke lever into "
• Press and release the throttle trigger to run idle.
Shut OFF
• Press and hold the switch in the OFF position until the
motor stops.
8
ENGLISH
" position (D).
" position (G).
Waist
• Double check the straps are properly adjusted to your back and
Movement
your body weight is well distributed on both feet.
• Keep the nozzle close to the ground.
WARNING
animals. Otherwise, you can cause severe injury.
• Press the trigger so that air starts flowing out through the nozzle.
• Move from one side to the other and rotate your waist. Keep the
nozzle close to the ground. Start sweeping leaves or residue.
Sweeping
Movement
Start Up
1 A
3
6 D
7 E
≤ 6
(1,2,3...)
Operation
• Do not point the nozzle towards people or
2 B
x10
4 C
5
≤ 8
8
F
9
G
(A,B,C...)
Publicidad
