Charging Indication; Removal / Insertion Of Battery - Promaker PRO-TI12KIT Manual Del Usuario

NOTE:
1 Allow the battery pack to cool completely before charging.
2 Inspect the battery pack before charging; do not charge a cracked or leaking
battery pack.

7.2 Charging indication:

The charger has two LED lights (4).
1 Plug the adapter (5) into suitable outlet. The green LED light will light to show
the power is connected.
2 Insert the DC plug (3) of the charger into the DC socket (2) on the battery. The
green light will be extinguished, and the red LED light will light to show the
battery is charging.
3 When the battery is loaded, the red LED light will be extinguished and green
LED light will light until the charger disconnect from the mains.
NOTE:
Please confirm that the battery pack is the correct model for this charger as
shown on the specification chart. Do not charge any other battery pack or any
battery pack that does not securely fit the charger.
1 Frequently monitor the charger and battery pack while connected.
2 Unplug the charger and disconnect it from the battery pack when finished.
3 Allow the battery pack to cool completely before using it.
4 Store the charger and battery pack indoors, out of reach of children.
NOTE:
If battery is hot after continuous use in the tool, allow it to cool down to
room temperature before charging. This will extend the life of your batteries.

7.3 Removal / insertion of battery

WARNING:
1 Before making any adjustments ensure the
drill is switched off with the reversing switch in
the center position.
2 Hold the drill with one hand and the battery
pack (9) with the other.
3 To install: pull and slide battery pack into
battery port, make sure the latch (8) on the
front side of the battery snap into place and
battery is secure before begging operation.
4 To remove: use your thumb and fingers, press the battery release latch in
and pull the battery pack off at the same time.
8