Rohde TS 20 Manual De Instrucciones Original página 40

6.4. Worktable assembly
6.4.1. General safety information
DANGER
Danger of physical injury!
When assembling, make sure that there are no limbs between the worktable and the
cutting device (cutting wire).
6.4.2. Assembly
Step Action
1 Take the pugmill from the pallet.
When delivered, the worktable is fastened to
2 the mixing barrel with straps. Remove the
worktable from the mixing barrel.
3 Remove any other pieces of packaging.
4 Remove the worktable mounting bolts.
5 Hold the worktable with its attachment points
in the position where the bolts were previously
removed.
Note:
Assembly by at least 2 people is
recommended.
6 Secure the worktable with the bolts removed
earlier.
38 / 191 - EN -
Illustration