Technical Specifications - EAS ELECTRIC EPLEX42 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DO NOT OPERATE ANY ELECTRICAL EQUIPMENT IN THE
PRESENCE OF A GAS LEAK.
5. After leak-testing is satisfactorily carried out, fit the rear
panel onto the heater. lt may be necessary to twist the
cylinder slightly to allow the regulator and hose to fit inside
the back panel without kinking the hose.
Note: The heater incorporates several safety devices that will
shut down the heater in unsafe
accidental flame failure, the gas heater will shut down
automatically.
tipped over if this activated. Set the heater upright, check for
obvious damage and again wait 5-10 minutes before
attempting to re-light the
operate if the heater is knocked against or bumped hard.
IN CASE OF GAS LEAK:
lmmediately close the cylinder valve if gas odor is detected.
Extinguish any naked flame.
Do not try again to turn on the unit.
Do not touch any electrical switch.
Do not use a telephone in your apartment/house/
Contact the gas supplier or our after-sales service or our
dealer and follow instruction

TECHNICAL SPECIFICATIONS:

Model:
Foldable model gas room heater
Gas: LPG (Liquid Petroleum Gas G30)
Gas pressure: 28 to 30 mbar
Category: 13+
Nominal flow (Max): 4.2kW-305g/h
Average flow:
Minimum flow rate:
3 injectors with a diameter of 0.58mm
lgnition: piezo-ignition
These devices will turn off the heater if it is
conditions.
heater.
This device may also
7
In case of
V.1

Publicidad

Tabla de contenido
loading

Tabla de contenido