Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING THE GAS CYLINDER:
•
Replacing the gas cylinder must be done in a non-
flammable, well-ventilated room. The appliance is
stopped.
•
Close the cylinder valve.
•
Disconnect and remove the regulator from the cylinder.
•
Replace the empty cylinder with a full gas cylinder valve
and eliminate leaks; if not call a qualified technician.
VENTILATION:
Your gas heater consumes oxygen when in
reason, adequate ventilation must be provided in the room
where it is
used.
combustion and allows a renewal of the air. Proper ventilation
should greatly reduce the risk of
shows you the proper ventilation so that the air is renewed
properly.
IN THE CASE OF PROBLEM:
The 2 most common problems associated with any gas heaters
are gas leaks, gas pressure that is bad, as well as dirt.
Check for leaks: The origin of the leakage may originate
•
from transport or installation. A solution of soap and water
buffered on the fittings will cause bubbles if gas leaks are
present.
Poor gas pressure: Too much gas pressure can seriously
•
damage your appliance. Little pressure does not allow your
device to function properly. lf the installer cannot verify the
gas pressure, consult your gas dealer.
Dust and dirt: This heating requires a little maintenance.
•
lf the spark does not stay on or if one part is not as bright as
the other, your heater probably needs a good cleaning.
This ensures the elimination of the products of
condensation.
10
operation.
For this
The table below
V.1
Publicidad
Tabla de contenido
