Rear Panel; Connecting With Bt; 100V Line System; Speaker Terminals - Power Dynamics PDW Serie Manual De Instrucciones

REAR PANEL

17. POWER IN AND FUSE HOLDER: Socket for plugging in the supplied power cord (top). For instructions on how to change
the fuse (bottom), see "REPLACING THE FUSE".
18. ZONE OUTPUT TERMINAL: These terminals allow for connecting speakers for different zones.
19. OUTPUT CONNECTIONS: Output connections for both low impedance and constant voltage distributed audio systems are
provided. The low impedance loudspeaker and 100V constant voltage output share a 4-PIN terminal block.
20. MUTE CONNECTION: Mute connection terminal. The amplifier will mute all other channels when short circuit this terminal.
21. PRE-OUT: RCA-connectors to allow connecting an external power amplifier instead of using the built-in amplifier. It allows a
signal to pass through the receiver without amplification, to instead be amplified by another power source.
22. LINE1 & LINE2 INPUT: RCA stereo line input connectors.
23. PHANTOM / MIC/LINE SWITCH: Switch 1 is for choosing between MIC2 and LINE3 channels. Switch 2 will enable phantom
power to MIC2 channel.
24. MIC2/LINE3 INPUT: Combi jack input (6.3mm jack, XLR) connector.
25. UNBALANCED MIC INPUT: 6.3mm jack microphone input. This input will mute all other channels when a signal is detected
(priority).
26. ANTENNA: Use an FM antenna to ensure the best possible FM reception.

CONNECTING WITH BT

If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.

100V LINE SYSTEM

For 100V line systems, connect the amplifier to the first speaker in the system using double-insulated speaker wire which has
adequate current rating to handle the total output of the amplifier.
Connect the "100V" output terminal to the positive (+) connection of the speaker and "COM" output to the negative (-)
connection of the speaker. Connect further speakers in parallel to the first speaker with all positive terminals and connected
together and all negative terminals connected together as shown below.
A 100V line speaker system can comprise of many speakers connected together. The determining factor for how many
speakers can be used on a single amplifier is the power rating. For most purposes, it is advised to connect as many speakers
as needed with a combined wattage of no more than 90% of the amplifier's output power rating.
The terminals of a 100V speaker are connected to a transformer and in some cases, this transformer may be "tapped" for
different power ratings. These tapings can be used to adjust the wattage (and output volume) of each speaker in the system to
help achieve the ideal total power of the system for the amplifier.

SPEAKER TERMINALS

These terminals are offering a low voltage output 8Ω. A 70V/100V commercial output is also available.
Please note that one wire only should be connected to COM screw and one wire to the selected impedance or voltage.
ATTENTION: Multiple combinations cannot be done at the output level.
Different types of connections are provided. The low impedance section (8Ω) is designed for a small amount of speakers to be
connected to your amplifier. The 70V/100V section is especially designed for a multiple speaker distribution. When using the
70V/100V output, speakers have to be equipped with 70V/100V transformer. The maximum amount of speakers to be placed on
your distribution line is in relation to the power allocated to each speaker. The total wattage set on the secondary side of the
transformers on your speaker line must not exceed the maximum RMS output power. Failure to respect this may cause
permanent damage to the amplifier.
1. Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Press the "BT" button and activate BT-function.
2.
Select "PDW-AMPLIFIER" on your BT-device and make the BT-connection
3.
4