Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP STEPS
1
2
P
P
3
SKADI
INSTRUCTION GUIDE
E
D
F
G
B
Back
P
C
P
L
M
L
Attach the casters (G) to the base (F). Then put
the gas lift (D) in the base (F) and place the
cover (E).
Place the 4 nylon washers (P) over the holes in
the base of the seat (B). Install the mechanism
(C) on the seat base (B) with 4 M8×20mm
screws (H), with the lever facing the back of the
seat. Once the chair is assembled, you will
operate it with your right
hand.
Identify the left and right armrests (M) and install
each on its corresponding side of the seat base
(B) using four M8X20mm screws (H).
7
ESP
EN
Publicidad
