Automatic Programming - EKSELANS AP 8 Manual De Usuario

Automatic programming

IMPORTANT REMARK: this amplifier includes an automatic programming system hereinafter explained. In
case you want to program manually the amplifier, please follow the steps explained from the following page.
1. When connecting the amplifier for the first time, the status LEDs will be as follows:
This indicates that the amplifier is ready to be programmed
2. To launch the automatic programming, hold the "Automatic programming" button for 5
seconds until the LED A flashes alternately from red to green. LED C will remain green color.
Important: the programming process would takes around three minutes. While this process is
taking place, do not press the "Automatic programming" button
3. Once programming is completed, the status LEDs will show the following status :
Note: refer to additional notes at the end of the manual
EN
A (red)
B
C (green)
A
B
C (green)
A (green)
B
C (green)
13