Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Additional notes
1. To restore the factory default settings (reset), disconnect the power supply, hold the
"Automatic programming" button and reconnect the power supply. The status LEDs will start
blinking from red to green. Keep holding the button about 15 seconds until LEDs shows the
following:
2. If signal's input levels are too low, the status LEDs will be as follows (LED A flashing red color):
If it happens, amplify the signal before the AP 8, make a reset as described in previous point 1
and restart the automatic programming
3. If signal's input levels are too high, the status LEDs will be as follows (LED A flashing red color
and LED C red):
If it happens, reduce the signal power before the amplifier, make a reset as described in previous
point 1 and restart the automatic programming
4. Remember that holding this button, you will be moved to upper level menu options
EN
A
(red)
B
C
(green)
A
(red)
B
(green)
C
(green)
A
(red)
C
(red)
C
(green)
19
Publicidad
Tabla de contenido
