TQ HPR Range Extender V01 160 Wh Manual Del Usuario página 7

3 Operation
3.1 Installing the Range Extender on the e-bike
The design of the mounting system for the Range Extender on the e-bike
depends on the manufacturer. This section shows how to mount the Range
Extender on the down tube of the e-bike using the FIDLOCK® system.
Make sure especially in case of retrofit that
no components of the e-bike such as the
battery or wiring harness are damaged when
installing the Range Extender.
Pay special attention to the following points:
— The assembly of the HPR Range Extender
may only be carried out by authorised
dealers. The personnel must be appropriately qualified, e.g. through
training as a two-wheel mechatronics technician. They must be able to
recognise possible dangers during assembly. Otherwise, there is a risk
that the Range Extender or other lithium-ion batteries on the e-bike will be
damaged or that the Range Extender comes loose during the ride due to
insufficient fastening.
— Selection of the correct screw heads and screw lengths.
— Selection of the positions recommended by the bicycle manufacturer for
the attachment.
3.1.1 Fitting the FIDLOCK® Bike Base to the e-bike
WARNING
Fire hazard due to damage to the battery inside the e-bike frame caused
by using screws that are too long.
► Only use the screws provided by the bicycle manufacturer or the
ISO 7380-1 M5 x 10 A2 button head screws included in the scope of
delivery to attach the FIDLOCK® Bike Base.
Using screws that are too long can damage the battery inside the e-bike
frame.
EN - 6