Descargar Imprimir esta página

Emerio HO-124421 Manual De Instrucciones página 6

Radiador de aceite

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
HO-124421
DESCRIPTION
1.
Heating elements
2.
Handle
3.
Thermostat knob
4.
Power switch with indicator light
5.
Wheel
6.
Cord storage
WHEELS ASSEMBLY
1. Assemble the four wheels to the two base shelves.
2. Turn the heater upside down.
3. Position the wheel base assemblies between the end fins.
4. Traverse the clips through the appliance body and base shelves.
5. Tighten the screw.
USING THE APPLIANCE
Set the thermostat to the minimal position "-" and insert the plug to the power supply.
Turn the thermostat knob in a clockwise direction to the maximal position "+".
Turn on the power switch according to the setting below. When the power switch is turned on, the
indicator light on the power switch will turn on.
a) Low setting: press switch I
b) Medium setting: press switch II
c) High setting: press both switch I and switch II.
Once the room temperature has reached the desired level, turn the thermostat knob slowly in
anti-clockwise direction until the indicator light turns off; this is the setting temperature.
The appliance will automatically maintain the setting temperature. It will switch on when the room
temperature is below the setting and switch off if it is above the setting.
If you want to change the room temperature setting, rotate the thermostat knob clockwise to raise the
temperature or anti-clockwise to lower the temperature.
NOTE:
The room must be in a good tight condition; if not, the heating results will be insufficient.
After use, press all the power switches to the position "0", and turn the thermostat knob to the minimal
position "-", and unplug the appliance from the power supply.
SAFETY SYSTEM:
The appliance has a safety system which automatically switches the unit off when overheated.
This heater is equipped with a tilt protection safety device. It has tilt protection safety functions and
automatically switches off the power. For safety reasons, the unit will automatically switch off the power if
it is put on unstable or uneven surfaces or if it is tilted accidentally.
- 5 -
EN

Publicidad

loading