Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
OPERATING INSTRUCTIONS
Releasing the
call/send button at
any time will stop
the lift.
When the VPL is not in use,
Bruno recommends raising
the unit off the ground to
approximately the mid-travel
position.
This will discourage
unwanted use by others and,
in colder climates, prevent the
underpanel from becoming
frozen in accumulated
ice/snow.
OPERATING IN COLD WEATHER
CAUTION
RISK OF
EQUIPMENT
DAMAGE
Use anti-corrosive de-icers or
sand to remove ice
and/or snow accumulations
on and near the VPL and to
eliminate slippery areas.
DO NOT use salt on or near
the VPL.
Salt can cause rust and
corrosion of metal parts.
©Bruno Independent Living Aids, Inc.
1.
Open the landing gate (if applicable).
2.
Move onto the platform.
3.
Lock the wheels of the mobility device (if
applicable).
NOTE: Wheels of mobility devices on board
4.
Insert the key into the call/send switch.
5.
Turn the key to the ON position.
6.
Press the top of the rocker switch to go UP.
Continue pressing until the platform automati-
cally stops at the top landing.
7.
Press the bottom of the rocker switch to go
DOWN. Continue pressing until the platform au-
tomatically stops at the bottom landing.
8.
Release the rocker switch.
9.
Turn the key to the OFF position.
10. Remove the key from the call/send switch.
11. Exit the lift.
If the temperature falls below 0° F (-18° C):
1. Park the platform in a raised position,
approximately mid-way up the tower.
2. When ready to operate the unit, check for the
presence of accumulated ice or snow on the
control buttons and underpan.
Remove ice/snow before operating the lift.
3. Run the lift down, then all the way up, then to
the desired level to board the platform.
This will warm up the nut and screw mechanism
to allow proper operation of the lift.
6
®
the VPL-3100B must remain locked
while the VPL-3100B is in operation.
VPL-3100B OPERATOR 08-15-2019
Publicidad
