Publicidad
Idiomas disponibles
Idiomas disponibles
SATEL
Full manual is available on
our website and download the manual.
The device should be installed by qualified personnel.
Before installation, please read the full manual thoroughly.
Changes, modifications or repairs not authorized by the manufacturer shall void your
rights under the warranty.
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly. Do not crush
the battery, cut it or expose it to high temperatures (throw it into the fire, put it in the
oven, etc.).
Do not expose the battery to very low pressure due to the risk of battery explosion
or leakage of flammable liquid or gas.
Be
particularly
The manufacturer is not liable for the consequences of incorrect installation of the
battery.
The used batteries must not be discarded, but should be disposed of in accordance
with the existing rules for environment protection.
The device is designed for indoor installation. The ART-200 radiator thermostat's place of installation
must be located within the radio range of the ABAX 2 controller. Thick walls, metal partitions, etc. will
reduce the range of the radio signal. Use the ARF-200 tester to check the level of radio signal. Place
the tester next to the valve on which you want to install the thermostat. If the radio signal level
indicated by the tester is higher than 40%, you can install the thermostat there.
The thermostat is fitted for radiator valves with the M30 x 1.5 mm threaded connection. It is
compatible with most radiator valves on the market. In order to install the thermostat on the Danfoss
RA valve, use the supplied adapter.
1. Use your fingers to press down the
element on Fig. 1). Pull to remove the cover.
2. Install two 1,5 V LR6 AA alkaline batteries (they are not supplied with the thermostat).
3. Add the thermostat to the wireless system (see ABAX 2 controller manual).
4. Replace the battery cover.
5. Install the thermostat on the valve.
6. Press
or
7. Configure the thermostat settings.
Hereby, SATEL sp. z o.o. declares that the radio equipment type ART-200 is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
Quick installation guide
www.satel.pl
careful
during
. The calibration will begin.
following internet address: www.satel.pl/ce
ART-200
. Scan the QR code to go to
installation
and
symbols on both sides of the battery cover (gray
replacement
of
the
3
battery.
Publicidad
