Publicidad
Idiomas disponibles
Idiomas disponibles
Parts description (fig. A)
1.
Handle
2.
Upper housing
3.
Height adjustment lever
4.
Open grill function button
5.
Control panel
Before first use
1.
Peel off and remove any packaging components.
2.
Clean the grill plates with a damp cloth or sponge and warm
water.
3.
Dry the device with a cloth or kitchen towel.
Note! Do not clean the device directly under a stream of running water.
Note! When using the device for the first time, a slight smoke or
unpleasant smell is possible. This does not affect the safe use of the
device. Unpleasant smells will cease with the next use of the product.
Operating manual
1.
Connect the device to a power source. The device will emit a
single sound and the switch (8, fig. B) will light up.
2.
Press the switch. The buttons on the control panel flash.
3.
Press the button of your choice, depending on the type of meal
you are preparing (9-13, fig. B), then press the OK button (14,
fig. B) or wait for the programme to switch on by itself after
about 5 seconds. The selected button will light up white and
the POWER LED (3, Fig. B) will flash red.
4.
The device will start pre-heating for approximately 4 minutes.
After this time, the device will beep three times and the READY
LED (4, fig. B) will light up green. The device is ready for use.
5.
You can set the time and temperature of your choice (see:
Time and temperature settings) or use one of the 5 preloaded
automatic programmes - steak, chicken, fish, toast, burger.
6.
Open the upper housing of the device, place the meal on the
grill plate and close the upper housing.
7.
By setting the height adjustment lever (3, fig. A) to the desired
position, you can select the degree of tilt of the lid (HIGH - big,
or LOW - small), or close the device completely. When closed,
6.
Non-stick grill plate
7.
Grill plate release buttons
8.
Lower housing
9.
Drip tray
EN
Publicidad
