Publicidad
Idiomas disponibles
Idiomas disponibles
6 - SETUP
Wall-mounting kit
IPN
Serrated washer L8 + H M8 nuts
Additional kit for IPN
Size
4300
Distance
mm
512
Reference
6.4 - Ceiling-mounted H4000 HELIOTHERME
Installation with ceiling-mounting kit
Installation only possible for HEATING applications.
Ceiling mounting using fluids at temperatures above
90°C is prohibited if the heat exchanger is still
supplied with fluid when the ventilation is switched
off. (Motor warranty invalidated if the motor is
damaged due to the thermal inertia of the coil)
To be provided by the client:
- M8 threaded rods
- Lock nuts underneath the inserts
Assembly procedure:
1. Remove the 8 x M8 screws. (Upper and lower section of the
HELIOTHERME
®
)
2. Fit the ceiling brackets and refit the M8 screws in their original
locations.
Installation with wall-mounting kit + additional kit on IPN
Support tube
H M8 x 50 screw
+ serrated washer
Mounting bracket
kit
Plastic end piece
H M8 x 70 screw + L8 plain washer
4350
4400
558
610
Code for additional kit for fastening on an IPN
7181228
Assembly procedure:
1.
Pre-assemble the clamping plates on the brackets using
the Ø 8 mm serrated washers and the H M8 nuts (not
tightened).
2.
Fit the bracket assemblies onto the support tubes by
sliding them over the end.
3.
Fix the legs of the wall bracket (7181226) using the 4
H M8x70 screws, the 4 x Ø 8 mm plain washers, the 4
x Ø 8 mm serrated washers and the 4 x H M8 nuts,
allowing the distances detailed above.
Move the support assembly onto the IPN and slide the
4.
bracket assemblies so that the lips are clamped onto the
IPN. Tighten the bracket nuts to lock the assembly in place.
5.
Fix the HELIOTHERME
screws supplied with the wall bracket.
4450
4500
710
808
®
M8 insert
EN-29
unit using the 4 x H M8 x 50
®
4630
4630S
943
943
7181230
Bracket identical on all
4 sides
M8 metric
screws
H4000 HELIOTHERME
EN
®
Publicidad
