CIAT MAGISTER Serie Manual De Instrucciones página 53

11 - TECHNICAL CHARACTERISTICS
Please follow the instructions on the CPY card configuration sheet provided with the unit.
11.2.4 - Condensate drain pump:
This option is only available if the humidifier option has not been requested.
Specifications:
- Electrical power supply: 230 V-50 Hz-90 W
- Max. flow rate: 500 l/h
- Max. discharge height: 5.4 m
- Integrated check valve
Table of actual flow rates for pump SI 1805
The pressure drops defined in this table
are calculated using 10 mm diameter
flexible piping
Connect a Ø 10 int (3/8") flexible tube (not supplied by CIAT) to the pump discharge.
For OVER models (3 and 5), if using a spreader beam and slings, the PVC tube will not be directly connected to the pump,
for handling reasons. It must therefore be angled in the right direction and fixed to the clamp, as shown below.
Condensate discharge
with check valve
Discharge
height
1 m
2 m
3 m
4 m
5 m
Total pipe length
5 m (l/h) 10 m (l/h)
460 380
390 320
300 250
200 180
90 80
EN-53
20 m (l/h) 30 m (l/h)
280 200
240 180
190 150
130 100
60 50
®
MAGISTER
EN