Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EXTRA
RECHARGE
SALT MONITOR
SYSTEM
Sometimes,
a manually
initiated recharge
(regeneration)
may be desired,
or needed.
Two examples
are:
• You have used more water
than usual (guests visiting)
and you may run out of soft water
before the next
automatic
regeneration.
• You did not add salt to the softener
before
it ran out.
Add salt to the softener
before
regenerating.
You can start a regeneration
immediately,
or you can
set the controller
to regenerate
at the next preset
recharge
time (2:00 AM, or as set).
RECHARGE
NOW
Press the REGENERATION
button and hold for 3 sec-
on__ad_ds
until the words "RECHARGE
NOW"
begin to
flash in the display.
The softener enters the fill cycle of
The water
softener
has a salt monitor
indicator
light to
remind
you to add salt to the storage tank.
NOTE: You must set salt level each time salt is added
to the water softener.
NOTE: The salt monitor
system estimates
salt levels, and
accuracy
will vary with different
salts.
To set this monitor system:
1. Lift the salt lid and level the salt in the storage
tank.
2. The yellow
salt level decal,
on the brinewell
inside
the tank, has numbers
from 0 to 8 (see Fig. 24).
Observe
the highest number the leveled
salt is at, or
closest to.
3. Press the SELECT button once, and the words "SET
SALT LEVEL" should show in the display.
regeneration
immediately.
This regeneration
will take
__
about 2 hours to complete.
Then, you will have soft
SETSALTLEVEL
0rine '--'FF
I
/i Fwe"'--'--
3:
_E'
Salt
|E
I
L'--
PM
Figure 22
Level
|
0
I
water
again.
RECHARGE
NOW
SET SAL T LEVEL
RECHARGE
TONIGHT
Press and release (do not hold) the REGENERATION
button.
"RECHARGE
TONIGHT"
will begin flashing
in
the display,
and the softener will begin regeneration
at
the next preset recharge
time (2:00 AM, or as set).
If
you decide
to cancel the regeneration
before it starts,
press and release the REGENERATION
button once
more.
"RECHARGE
TONIGHT"
will stop flashing
in the
display.
RECHARGE
TONIGHT
I
l!--
pMI
Figure
23
Figure 24
4. Press the f
UP or V
DOWN
buttons to set the salt
level to match the number on the decal.
At level 2
or below, the "Low Salt" indicator
will flash.
If you
want to turn the salt monitor
off, press the V
DOWN
button
past 0, until "SALT LEVEL OFF" shows
in the display.
5. When the correct
salt level is displayed,
press the
SELECT button,
and the display
will return to the nor-
mal run (time of day) screen.
Figure 25
Questions?
Call the Kenmore
Water
Line 1-800-426-9345
or visit www.kenmorewater.com
16
Publicidad
Tabla de contenido
