Sears Kenmore 625.383000 Manual De Uso Y Cuidado página 20

MANUALLY INITIATED ELECTRONIC DIAGNOSTICS
1. To enter diagnostics, press and hold the SELECT but-
ton until "000 - -" shows in the display.
I-II-ii-I
UUU - -
Figure 32
TURBINE OPERATION: If no water is flowing through
the softener, the turbine indicator displays three zeros.
When water is flowing, a 000 to 199 count repeats for
each gallon of water passing through the turbine. To
check for positive operation of the turbine if zeros are
shown, open a nearby soft water faucet and observe
the turbine count. If you don't get a reading in the dis-
play with faucet open, pull the sensor housing from the
valve outlet port (see Fig. 34). Pass a small magnet
back and forth in front of the sensor. You should get a
reading in the display. If you get a reading, unhook the
inlet and outlet plumbing and check the turbine for
binding.
l-l rl l-i _ FI
uuu
Figure 33
POSITION SWITCH STATUS: With the valve in service,
or any of the recharge cycle positions, the position
switch indicator will show two dashes (switch open).
While the valve is rotating from one position to another,
the position switch indicator will show the letter "P"
(switch closed). There is likely a problem if indications
vary from this pattern.
OTHER INFORMATION: While in the diagnostics
screen, the following information is available and may
be beneficial for various reasons. This information is
retained by the electronic controller from the first time
electrical power is applied to the unit.
• Press and hold the /X UP button to display the num-
ber of days this controller has had electrical power
applied.
• Press and hold the V DOWN button to display the
number of regenerations initiated by this controller
since the model code number was entered.
Motor ]
Position Sensor
Switch j Housing
i Turbine
J Turbine
Support
& Shaft
Valve Outlet
Figure 34
NOTE: If the electronic controller is left in the diagnos-
tic display (or a flashing display when setting
times or hardness), the normal time of day dis-
play automatically returns if a button has not
been pressed for 4 minutes. To return to the
diagnostic display, repeat step 1, above.
RESETTING TO FACTORY DEFAULTS
To reset the electronic controller to its factory default
for all settings (time, hardness, etc.):
1. Press the SELECT button and hold it until the display
changes twice to show "SET CODE" and the flashing
model code.
2. Press the /X UP button to display a flashing "SOS".
SET CODE SET CODE
Figure 35
3. Press the SELECT button, and the electronic controller
will restart.
4. Set the present time, hardness, etc., as described on
pages 13 & 14.
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
2O