Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use the appliance
6mm
3mm
The following symbols will appear on the control panel, next to each control handle:
Black circle: gas off
Large flame: maximum setting
Small flame: minimum setting
The minimum setting is at the end of the anti-clockwise rotation of the control handle.
All operation positions must be selected between the maximum and minimum position.
The symbol on the control panel,next to the control handle will indicate which burner it
operates.
Automatic ignition with flame failure safety device
The appliance is fitted with a flame failure safety device on each burner, which is
designed to stop the flow of gas to the burner head in the event of the flame going out.
To ignite a burner:
○
Press in the control knob of the burner that you wish to light and turn it anti-clock-
wise to the maximum position.
○
If you keep the control knob depressed, the automatic ignition for the burner will
operate.
○
You should hold down the control knob for 15 seconds after the flame on the
burner has lit. If after 15s the burner has not lit, stop operating the device and
open the compartment door and/or wait at least 1 min before attempting a further
ignition of the burner.
○
After this 15-second interval, to regulate the flame you should continue turning
the control knob anti-clockwise until the flame is at a suitable level. The operat-
ing position MUST be at a position between the maximum and minimum
position.
○
To switch the burner off, turn the control knob fully clockwise to the gas off
position.
○
In case of power failure, the burners can be lit by carefully using a match.
3mm
10
Publicidad
