probst RK-I-US Instrucciones De Uso página 41

Installation
4.1.6 Attachment with crane boom (optional)
The crane boom has 4 suspension eyes (A) to lift it with suitable
chains/hoisting straps (with the help of an appropriate hoist) -
for positioning on the forklift truck to which it is later to be
mounted.
It is also allowed to lift and transport a gripping device (without
load) mounted on the crane jib at the lifting eyes (A).
Lifting and transporting on the lifting eyes (A)
with a load (gripping good) is prohibited!
There is a risk of breakage of the lifting eyes!
When lifting and transporting the crane boom,
persons must not stand in in close proximity.
Standing under a suspended load is forbidden!
Attention! Danger of squeezing the hands during
assembly work!
To mount the crane boom to the forklift truck, position the lift
plate ① of the forklift truck under the upper fastening claws ②
of the crane boom and then attach the lower fastening claws ③
to the lift plate ① using the attached fastening screws.
Attention: Observe the maximum permissible torque of the
fastening screws!
When mounting the crane boom, make sure that it is positioned
(as far as possible) centrally on the lifting plate ① and that the
shift protection ④ is used in the next possible groove ⑤ on the
lifting plate ①.
⑤
57200032
①
13 / 21
②
③
GB