INTERTECHNO ITW-801 Manual De Instrucciones página 28

GB
The wireless wall transmitter ITW-801 and wireless 2-gang wall trans-
mitter ITW-802 (Fig.1) are compatible with all intertechno self-learning
wireless receivers for switching.
Wireless adapters and flush-mounted switches for all light sources (such
as LEDs) are available.
The automatic turn-off time is ideal for many applications and to save
energy.
Removing battery strips/changing batteries (Fig.2)
The battery fuse must be removed first.
To do this, use a screwdriver to take off the mounting plate.
The + symbol must face upwards when you insert the battery.
The CR2032 3V battery will last for approx. 20,000 operations (lifetime of
around 3 years)
The LED will light up red every 4 seconds when the battery is running
out.
When closing the wireless wall transmitter with the mounting plate,
ensure that the arrow of the mounting plate and the arrow on the back
of the wall transmitter are both pointing upwards.
All 6 clips must properly click into place. If done correctly you should
hear a distinct click.
ENCODING - Teaching in a wireless receiver (Fig. 3)
To adjust the encoding, please also read the operating instructions of
your self-learning wireless receiver.
Place the wireless wall transmitter near the wireless receiver.
1.) Put the wireless receiver in learn mode.
2.) Transmitting the on signal to the wall transmitter causes the LED to
light up green and the wireless receiver applies the encoding.
Erasing encoding
To erase the encoding, repeat steps 1.) to 2.) as above, but now the off
signal is sent instead.
The LED will light up red two times.
Setting the automatic turn-off time
No matter which time is set, it is always possible to prematurely switch
off the device.
Press the on and off button at once for 3 s to adjust the setting.
The LED flashes green.
Operating instructions
ITW-801
ITW-802
›