Descargar Imprimir esta página

Danby Designer DER243BSSC Guía De Utilización Y Cuidado Para El Propietario página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

USING THE CLOCK, TIMER AND CONVENIENCE OUTLET (some
models)
TO SET THE CLOCK
1. Touch CLOCK pad and hold for 3 seconds, until the display starts fl ashing.
2. Touch the + or – pads until you reach the desired time.
3. When you let go of the + or – pad the time will be set.
TO SET THE TIMER
1. Touch TIMER pad and hold until the display starts fl ashing.
2. Touch the + or – pads until the amount of time you want shows in the display. The maximum time that can be entered
in minutes is 59 (0:59). Times more than 59 minutes (0:59+) should be changed to hours and minutes (i.e.1:05, 1 hour,
5 minutes). The maximum time that can be set is 9 hours and 50 minutes (9:50).
3. When you let go of the + or – pad, the time will be set. This is indicated by the green light beside the TIMER pad no
longer fl ashing.
4. When the timer reaches :00, the control will beep. Touch the TIMER pad to end timing.
If you make a mistake, touch the TIMER pad and begin again.
TO RESET THE TIMER
If the display is still showing the time remaining, you may change it by touching the + or – until the time you want ap-
pears in the display.
TO CANCEL THE TIMER
Touch the timer pad once
CONVENIENCE OUTLET (some models)
OPERATION INSTRUCTIONS
The 120V convenience outlet located on the top of the back guard
may be used to plug in small electrical appliances.
When using the outlet, be sure that the electrical cord does not rest
on or near a surface unit. If the surface unit is turned on, the cord
will be damaged.
To reset the circuit breaker, press the switch located near the outlet
on top of the back guard.
10

Publicidad

loading