Gima 2204 Guia Del Usuario página 4

1 ABOUT THIS MANUAL
This manual shall only be used for the reference of operation of this particular model. If the manual is used for other purposes, we will not under-
take any according consequences and responsibility.
All information of this manual shall be protected by copyright and shall not be copied and translated in any part of this specification without the
written consent of manufacturer.
2 WARNING
• Do not stand on this equipment.
• Do not allow children to play with and place the equipment in a place where children can touch;Please adjust the backrest to the highest position
when you leave.
• Please do not place !ha equipment in wet places such as bathroom to avoid electric shock or other failure; Controllers should also avoid contact
with water.
• Please do not place and operate the equipment in places where is painting/coating or supplying oxygen.
• Unless being monitored or instructed by personnel who can be responsible for their personal safety, the people who have physical obstacles,
tactile disorders, mental disorders, jack of experience, common sense or children,are not allowed to use the equipment.
• Please make sure there is no accessible thing within the stroke during any operation of the beds.
• Operation should be processed by trained professionals.
3 PRECAUTIONS
• The equipment should be in charge by an experience person who must be familiar with the product structure, performance and use methods.
And make the regular maintenance work.
• Read this manual carefully before installation, operation and adjustment. And please keep it well.
• This product shall not be used for single side or single point loading work.
• Comply with safety operation rules, do not overload the use of products, to ensure that the product safety protection equipment is complete and
reliable, eliminates unsafe factors on time.
• Tighten bolts and nuts regularly to avoid failure caused by loose,sliding, vibration and falling parts.
• During the maintenance, the operator shall not disassemble any parts of the bed at will.
• This product is not allowed to operate when it's with fault. If abnormal phenomenon or abnormal sound is found, it must be stopped for inspection
immediately, and work can be resumed after troubleshooting.
• The operator must be familiar with the precautions described in each section of the manual to ensure the safety of person and product.
• Please operate the equipment strict accordance with the warning label pasted to the products.
• Maintenance should be processed by trained professionals.
• After each treatment, please use neutral reagent to clear the dust, stains on leather or on wood pieces.
• When unpacking the beauty bed, adjusting the backrest angle, seat inclination, and bed height.
Do not put your hands, feet, head, or any body parts in or between en gaps (as shown in the picture below).
4 APPLICABLE RANGE
These beauty beds are suitable for beauty, massage and manicure treatment.
5 INSTALLATION
1. Put the bed to a proper location, according to the overall layout, the daylighting or artificial lightings and operation condition of the salon's or the
home. And keep in the clean, dry and cool environment.
2. Open the packing carton to check if the bed is intact and whether the accessories or spares are complete. Please contact distributor or us if
there's any problem.
3. Installation
Place the bed to the proper position. Please note that it is unnecessary to install extra screw on the floor to fasten the bed, because the original
design has taken the stability performance into consideration. But please ensure the bed is placed on a firm and flat ground, so as to prevent
any accident.
Installation Guide for Beauty Bed Model2260
If the bed rotates or slant due to rough ground, please adjust the four pieces of plastic feet (M10x30) and nuts (M10) by hexagon open-end
wrench, which are fasten on the bottom panel, so as to ensure the bed is stable.
ENGLISH
4