Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING A POWER HEAD ATTACHMENT
WARNING:
attachment used with this power head and follow all warnings and instructions. Failure
to follow all instructions could result in electric shock, fire and/or serious personal
injury.
WARNING:
only with the EGO attachment models that are specified in this Operator's Manual or
subsequently introduced by EGO for use with this power head. Use of other unauthorized
attachments could cause serious personal injuries or property damage.
WARNING:
Always pay special attention to such instructions in the manual that accompanies each
accessory.
WARNING:
head is running or with the battery installed. Failure to stop the motor and remove the
battery can cause serious personal injury. NEVER OPERATE THE POWER HEAD WITHOUT
AN ATTACHMENT.
The attachment connects to the power head by means of a coupler device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Remove the end cap from the attachment and place it in a safe place for later
use. Align the arrow on the attachment shaft with the arrow on the coupler
(Fig. 2a) and push the attachment shaft into the coupler until you hear a clear
"click" sound. The coupler should be positioned all the way to the RED LINE
labeled on the shaft for the attachment shaft to be properly mounted into place
(Fig. 2b).
Read and understand entire Operator's Manual for each optional
This 56V power head PH1420/PH1420-FC is designed to be used
Some accessories have specific requirements related to safety.
Never install, remove, or adjust any attachment while the power
56-VOLT LITHIUM-ION POWER HEAD — PH1420/PH1420-FC
17
Publicidad
