Publicidad
4. BATTERIES REPLACEMENT
1. Slide the front cover of the remote controller to access the batteries.
2. Remove the old batteries.
3. Insert two new batteries AAA 1,5V and make sure to place them in the right pole.
4. Slide the front cover back.
Notes:
1. Do not put the used or different batteries into the remote controller, otherwise remote controller
will fail to send signal.
2. Please remove the batteries before long period unused, otherwise the remote controller may be
damaged.
3. If no receiving sound is heard from indoor unit or on remote controller does not flash, please
replace the batteries.
4. The batteries mut be removed from the remote control before if is disposed. Batteries must be
disposed of safely.
5. OPERATING MODES
Auto Mode
Press MODE button to select the Auto operating mode:
-
Adjust the set point temperature by using
-
Press ON/OFF button to turn on / off the fan coil unit.
-
The fan speed cannot be adjusted in this mode.
Cool / Heat / Fan Mode
Press MODE button to select the desired operating mode: Cool / Heat / Fan.
-
Adjust the set point temperature by using
-
Press ON/OFF button to turn on / off the fan coil unit.
-
In Fan Mode, the set-point temperature cannot be adjusted. The economic operation cannot be
selected in this mode.
Dry Mode
Press MODE button to select the Dry operating mode:
-
Adjust the set point temperature by using
-
Press ON/OFF button to turn on / off the fan coil unit.
-
The fan speed cannot be adjusted in this mode.
and
.
and
.
and
.
Publicidad
