Publicidad
Idiomas disponibles
Idiomas disponibles
New Camera Pairing
10
The cameras have been paired before leaving the factory, NVR will automatically display
video after powering on the camera system. It is recommended that users conduct a
power-on test before installation to ensure that each camera can work normally. If it fails,
please contact our customer service.
If you want to add a new camera or reset the camera, please follow the following steps. Take
out the camera, install the antenna, connect NVR and camera with a network cable. Make
sure that NVR can display normally on the monitor, and then perform the following opera-
tions:
1.
Right click the mouse, the main menu will come out.
2.
Select and enter IPC Channel Config page.
3.
Click the Search on the IPC Channel Config page to search for the corresponding IPC.
4.
Double-click the searched cameras, or tick the camera and click WiFi Add. The status of
IPC connected shows at the bottom of the page, and the corresponding monitoring video will
display.
12
Publicidad
