Descargar Imprimir esta página

Tascam SB-16D Manual Del Usuario página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
Device ID settings
When using an SB-16D with a Sonicview 16/24, the device ID must be set to enable identification of the unit.
Follow the procedures below to check or change the device ID.
Checking the device ID
Press the ID (8) button.
The unit will enter device ID checking mode, and the STATUS and SAMPLE RATE indicators will blink.
INPUT SIG indicators and OUTPUT SIG indicators will light at the same time according to the device ID number.
The device ID is assigned by pairing the numbers of the input and output channel indicators.
For example, indicators will light for the following ID numbers as shown in the tables.
Device ID: #3-4
Channel number
INPUT SIG indicators
OUTPUT SIG indicators
Device ID: #15-8
Channel number
INPUT SIG indicators
OUTPUT SIG indicators
i Indicators that light when in device ID confirmation mode
Changing the device ID
Follow the procedures below to change the device ID.
ATTENTION
Be careful to set the device ID for this unit so that it is not the same as another SB-16D connected to the same network.
1.
Press and hold the ID (8) button for 10 seconds.
The STATUS and SAMPLE RATE indicators will light simultaneously along with OUTPUT SIG indicators according to the device ID
number (twice per second).
2.
When in device ID changing mode, press the ID (8) button to change the device ID.
The blinking OUTPUT SIG indicator will change.
3.
Press and hold the ID (8) button for 2 seconds to confirm.
After entering device ID changing mode, each time the ID (8) button is pressed, the device ID will be increased by one (+1). The
blinking OUTPUT SIG indicator will also change in order according to the device ID number.
After the OUTPUT SIG indicator reaches 16, pressing the ID (8) button again will return to OUTPUT SIG indicator 1.
ATTENTION
When changing the device ID with this unit, changes with OUTPUT SIG indicators 1–16 are possible.
To change INPUT SIG indicators, do so from a Sonicview 16/24 or using the TASCAM IO CONTROL application.
12
TASCAM SB-16D
1
2
3
4
5
0
0
1
2
3
4
5
6
7
8
9
10
6
7
8
9
10
0
11
12
13
14
15
11
12
13
14
15
0
16
16

Publicidad

loading