Descargar Imprimir esta página

Reliable THE LONGBOARD 350LB Manual De Instrucciones página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

ATTACHING THE IRONING BOARD COVER
1. Lay the ironing board cover over the frame of the pressing surface.
2. Stretch the cover over the corners, sides, and tip of the ironing board ensuring
that the cover is fulling wrapped over the pressing surface.
3. Pull the strings at the tip of the cover downwards to secure the cover tightly in
place. Ensure that you are using enough force on the strings to remove any
surface wrinkles.
4. Pull the clips under the pressing table and secure them to the opposite side of
the cover (350LB extension cover only).
5. Firmly pull on the strings once more to remove any remaining wrinkles and
ensure the cover is tightly in place.
WASHING YOUR IRONING BOARD COVER
Wash on a delicate cycle and hang to dry. If you do not have a delicate setting on
your machine, use a short wash cycle with cold water or wash by hand with gentle
soap. Rinse thoroughly. Hang straight or lay flat to dry.
USING THE IRONING REST
1. For iron stations, place the base of the iron station on the removable iron
rest.
2. For home irons, fold both the metal plates inward on a 45° angle. This will
allow the iron to sit within the iron rest on the silicone knobs.
3. There are four silicone knobs on the iron rest. Silicone is heat resistant and
allows you to place the soleplate on the iron rest when in use.
4. Do not exceed the recommended maximum weight of 5.7kg. Do not lean or
put extra weight on the iron rest.
8

Publicidad

loading