Publicidad
Idiomas disponibles
Idiomas disponibles
HUMIDIFIER OPERATION
You can control your humidifier through the control panel of the humidifier or
through the control panel of your SPC IoT application.
1.
Remove the top cover, fill the tank with water, and replace the top cover.
Another alternative is to remove the tank by holding it by the handle to
fill it under the tap. Once full, put it back on the base making sure the
SPC logo is on the front so the orientation is correct.
2.
Once plugged in, the LED display will blink once and a beep will sound.
After that, the humidifier will go into standby mode.
3.
Touch the "ON/OFF" button
on or off. When it's on, the night light will turn on. The display will show
the current humidity. 15 seconds later, the display will change to show
the mist level "2". The humidifier operates at a default mist level of
"2". The display will alternate every 15 seconds between the current
humidity level and the mist level.
Press and hold for a few seconds to enter Wi-Fi pairing mode.
4.
Touch the "MAX/MIN" button
medium, 3= high. If the display is showing the current humidity, press
once to see the mist level and a second time to change it.
5.
Touch the "HUMIDITY"
humidity level from 30% RH to 90% RH. Press again to increase the
humidity 5% RH each time. (Press the button until the display shows
"Co" to deactivate the continuous humidity mode).
The display will blink three times with the set value and then change to the
current value. After this, the humidifier will go into continuous humidity
mode.
In continuous humidity mode, the mist level is not adjustable. The humidifier
will adjust automatically.
•
When the target humidity is greater than 16% RH relative to the current
humidity, the humidifier will operate with a mist level of 3.
on the control panel to turn the device
to adjust the mist level: 1= low, 2=
button to set the desired continuous
19
EN
Publicidad
