VONROC SA501AC Traducción Del Manual Original página 13

Using the raker blade (Fig. I)
• By raking you remove the dead matter, moss and
weed which disfigures a lawn. The build up of
dead grass provides a mat of absorbent fibres
which prevents water getting through to the
ground.
• Do not force your rake through grass that is
longer than 75mm. The lawn must be dry when
using the machine. It's recommend that this is
used at the beginning and the end of each grass
cutting season to give your lawn a thorough rak-
ing. This could also be used after each mowing
to remove any grass cutting that may be left by
your mower.
Proper use (Fig. L)
• For best results, place the machine on the edge
of the lawn and work in forward direction. Then
turn at the end of each run and mow in the oppo-
site direction, slightly overlapping the previously
cut strip. Also refer to figure L.
• Make sure that the lawn is clear of stones, sticks,
wire or other objects that could damage the
product or its product.
• Circle around flower beds. When reaching a flow-
er bed in the middle of the lawn, cut a row or two
around the circumference of the bed.
• Pay special attention when changing direction.
• Always work along inclines (not up and down).
You can prevent the machine from slipping down
by holding a position at an angle upwards.
• Empty the grass catcher regularly.
• For best results, your lawn should be scarified
every 4-6 weeks.
• We recommend scarifying the lawn in Spring and
Autumn.
• We recommend aerating the lawn during the
entire growing period.
Storage
Store the machine in a secure, dry place out of the
reach of children. Do not place other objects on top
of the machine.
• To store the machine, fold the upper and lower
handle downwards towards the machine.
• A wall bracket (11) is included with the deliv-
ery to mount the machine onto a wall when
preferred. Use the provided screws to mount
the wall bracket. Use appropriate wall plugs if
necessary.
WWW.VONROC.COM
5. MAINTENANCE
Your machine has been designed to operate over
a long period of time with minimum of mainte-
nance. Continuous satisfactory operation depends
upon proper machine care and regular cleaning.
• Keep the machine clean and dry.
• Regularly use a blunt scraper to remove grass and
dirt from the machine.
• To clean the machine, use only mild soap and
a damp cloth. Never let any liquid get inside the
tool and never immerse any part of the tool into
liquid. Do not use any abrasive or solvent - based
cleaner.
Stop the blade(s) if the machine has to be tilted for
transportation when crossing surfaces other than
grass, and when transporting the machine to and from
the area to be used.
Do not start the machine when standing in front of the
discharge opening.
Always allow the machine to cool down before storing.
Replace worn or damaged parts for safety. Use only
genuine replacement parts and accessories.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
EN
13