Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Installation et fonctionnement
Thank you for purchasing the single tube washing machine.
•
Please read these instructions carefully in order to operate the machine properly.
•
Keep this manual handy for further reference.
Washing capacity
Outer dimension
Weight
CLASS: IPX4
Name of Parts
1.
Wash timer knob
2.
Pulsator
3.
Wash tub
4.
Base
5.
Power cord
6.
Drain hose
7.
Lid
8.
Water supply port
Accessories
1.
Water supply hose
2.
Owner's manual
3.
Drain hose
Installation and Operation
Before Wash
1.
Place the machine on a firm and flat floor (allow most oblique angle to 2"). If the machine is not leveled, the machine may make a
big vibration and noise.
2.
Suspend the drain hose on the hose hook at the right side of the machine. Just lay the drain hose down when you want to discharge
the water.
3.
Set the water supply hose. Connect one rubber packing of the water supply hose to the end of tap, connect the other one to the
water supply port on the machine.
4.
Plug the power cord into the socket. In case of the machine with two conductor power cord, be sure to connect the ground wire to a
proper ground. Never connect the earth wire to a gas pipe, a tap water pipe, a phone wire and lighting rod.
5.
Check the laundry. According to the indication of the items, confirm whether it can be washed or not.
The following are those that cannot be washed.
•
Blanket
•
Clothes with oil, solvent sand chemicals
•
Cloth shoes, etc.
Washing Guide
1.
Put the laundry into the wash tub. Turn the tap, let water into the tub according to the amount ofclothing to be washed (The marks
H.M.L. in the inner tub are high, medial and low water level).
2.
Add proper amount of detergent. If the amount of detergent is too much, the laundry can't be rinsed sufficiently. So please add
proper amount of detergent.
3.
Turn the 'wash Timer' knob to the desired wash time clock wise; the washing action will begin. Set the washing time according to
how the laundry soiled or its amount. Normally, the time for low soiled laundry is around 8 minutes, while it's more than 12 minutes
for extremely soiled laundry.
4.
After washing is completed, drain the water by laying down the drain hose. Twist the 1aundry and prepare for rinsing.
5.
The washing machines have vents, which should not be blocked in order to prevent overheating.
Rinsing Guide
1.
Suspend the drain hose again, put dry laundry into the tub, and then let water flow into dry tub at the proper level.
2.
Set the rinsing time by turning the washing timer. Normally, the rinsing time is set to around 5 minutes.
3.
After rinsing is completed, drain the water by laying down the drain hose and twist the 1aundry.
4.
Repeat the above steps 2 to 3 times.
395*395*540 mm
350*360*515
5 kg
5 kg
8
7
6
1
2
3
4
5
Publicidad
