SNOWJOE sunjoe 24V-X2-LS6T-CT Manual Del Operador página 8

Battery
Fig. 1
2. Depending on your Snow Joe
model, how to recharge your lithium-ion battery will vary.
You may either insert your 24-volt battery into the
24VCHRG-QC Quick Charger (sold separately) or the
24VCHRG-DPC Dual-Port Charger (sold separately)
(Figs. 2 – 3).
Fig. 2
Battery pack
Charging
red
24VCHRG-QC
Quick Charger
(sold separately)
Fully
Charged
green
Fig. 3
Charging
red
Fully
Charged
green
+ Sun Joe charger
® ®
Battery pack
24VCHRG-DPC
Dual-Port Charger
(sold separately)
3. The battery indicator LEDs will illuminate one by one
during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
4. The 24VCHRG-QC Quick Charger (sold separately) and
the 24VCHRG-DPC Dual-Port Charger (sold separately)
are also equipped with additional charging indicating
lights that will indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
m
WARNING!
Accidental starting may result in serious
personal injury; always remove the battery packs from the tool
before assembly.
1. Install the handle onto the front stand using the included
set of socket head screws, washers and lock nuts (Fig. 4)
Lock
nut
Washer
8
Fig. 4
Handle
Socket
head
screw