SNOWJOE sunjoe 24V-X2-LS6T-CT Manual Del Operador página 9

2. Assemble the control lever using the hinge and cotter pin
(Fig. 5)
Fig. 5
Hinge
Cotter pin
3. Screw the grip into the control lever at the back of the log
splitter (Fig. 6).
Fig. 6
Operation
TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY
In order to operate this cordless log splitter, you will
need two batteries and one charger from the 24V iON+
System. See page 12 for battery and charger options and
specifications, or visit snowjoe.com.
1. Before using the log splitter, loosen the bleed screw three
or four turns counter-clockwise to allow air to bleed out of
the hydraulic system (Fig. 7).
NOTE: To avoid hydraulic oil leaking, tighten the bleed
screw before transporting the machine.
2. Slide both batteries into the battery compartment (Fig. 8).
Battery
Fig. 8
Grip
3. Load a single log lengthwise onto the log rail. Always split
along the grain of the wood and not against.
NOTE: Do not exceed the maximum log diameter of 10 in.
(25.4 cm) or the maximum log length of 20.5 in. (52 cm).
m
WARNING!
pusher is moving.
4. To start splitting, push the power button with your
right hand and pull the control lever with your left hand
simultaneously (Fig. 9).
NOTE: Knots, green woods or hard woods may present
additional resistance for the log splitter. Do not force the
machine if the log does not split on the first attempt.
Control
lever
9
Bleed screw
Never load or unload logs while the log
Power
button
Fig. 7
Fig. 9