Publicidad
Power cord
protector
Handle
Power
cord
Spindle
lock
Velcro
disc
D-Handle assembly
• Align the D-Handle with the polisher head and match
the screw orifices.
• Screw firmly the D-Handle to the polisher head using
the included screws.
Disc Assembly
• Adhere the bonnet to the Velcro disc.
• Press the spindle lock (A) and mount the disc into the
polisher head. Screw it tight.
• To remove the disc, press the spindle lock and unscrew
the disc.
CAUTION
• The spindle lock can only be
tightened when mounting or dismounting the disc. It shall
never be pressed to stop the disc while polishing.
Otherwise the tool may get damaged and exposes you to
personal injury.
• The mounting (installation) threads of the fittings must
match the threads of the shaft (spindle). For fittings that
are installed with flanges, the shaft entry hole to the fitting
must match the flange diameter.
• Fittings that do not match the power tool installation
devices cause imbalance, excessive vibration, and may
cause loss of control.
6
ENGLISH
Speed
control
D-Handle
Carbon brush
housing cap (x2)
Polishing
bonnet
Assembly
• Do not use a damaged accessory. Inspect accessories, for
example, before each use:
1) Check for damage and cracks.
2) Check the backrests for cracks, tears or excessive wear.
3) Check base for cracks.
• If power tool or attachment is dropped, inspect for damage
or install a attachment with no damaged. After inspecting and
installing an attachment, stay clear and keep people away
from the plane of the rotating attachment, run the power tool
at maximum speed without load for one minute.
• Damaged attachments usually break during this time.
Parts
Velcro
disc
Lock-on button
Trigger
switch
Orifices to screw on
the D-Handle
5/8-11-UNC-1A
Spindle
lock
Polishing
bonnet
Handle
A
Publicidad
